Contact Products
Support About
Home
Joker Poker 2000/2004
Program Setup Instructions
| 8 way Switch
Settings on Game PCB |
| Switch | OFF | ON | Function |
| 1 | 2p | 10p | Bet
Units |
| 2 | Credit | Payout | Play
Mode |
| 3 | £1
= 10p |
| Coin
Control |
| 4 |
| | Always
OFF |
| 5 | |
| Always
ON |
| 6 |
| | Always
OFF |
| 7 |
| | Always
OFF |
| 8 | Clear |
| Memory
Clear |
Credit
/
Payout Modes
Switch 2 Controls the Payout (Hopper) or Credit
Mode, OFF for Credit
Play, ON for Payout Play, Refill and Cashbox Switch functions will
change
accordingly.
Payout Machines
Hopper Float is 200 – Refill as normal through
Refill key – Auto refill
(in 10 coin steps) is available through Cashbox Key using refill menu
with
gamble button.
Each Hopper payout is limited to £15, (“HIT
HIGH FOR PAY”)
Credit
Machines
This program is intended for Hi-Lo style
Cabinets – the credit only
style (Nourat Deluxe) cabinet uses a ‘Cancel Holds’ button
which should be
disconnected as its is the 10p credit line with Hi-Lo Cabinet
programs.
Setting
Game Up
To Set Maximum Bet / Target Percentage / Speed
of Deal
1)
Press
the Cashbox Switch
2)
RESET
REFILL READOUT should appear, press the Hold 5 Switch for READOUT
3)
Quickly
Press the HIGH button Until
BET /
SPEED / TARGET Appears
4)
The
TARGET % can be changed by using HIGH / LOW Switches
5)
Move
to
SPEED by pressing DEAL SWITCH
6)
The
SPEED can be changed by using HIGH / LOW Switches
7)
Move
to
BET by pressing DEAL SWITCH
8)
The
BET
can be changed by using HIGH / LOW Switches
9)
Finish
By Pressing Hold 5
TARGET
-
recommend setting to 72%
SPEED
- recommend setting to 11
BET
- the maximum bet, usually 30p in Ireland/England
using switch 1 Setting at 10p (ON)
Clearing
Memory
Switch
8 is checked by the
software only on power up – so to clear memory:
1)
Machine
is turned off
2)
Switch
8
should be turned ON
3)
Turn
Machine On
4)
No
cards
will be displayed on screen
5)
Switch
8
should be turned OFF
6)
memory
is now cleared
7)
The
BET/SPEED/TARGET will need to setup
Recommend
Payout (Hopper)
Settings :
Switch
1 ON
Switch
2 ON
Switch
3 ON
Switch
4 OFF
Switch
5 ON
Switch
6 OFF
Switch
7 OFF
Switch
8 ON
Recommend
Credit Play
Settings :
Switch
1 ON
Switch
2 OFF
Switch
3 ON
Switch
4 OFF
Switch
5 ON
Switch
6 OFF
Switch
7 OFF
Switch
8 ON
Refill Mode
Refill mode is used to setup machine hopper
level from installation or
in case of large payout.
‘HOPPER PROBLEM’ may be displayed on-screen
informing that the hopper
has failed to pay requested coin amount – Hopper refill must be used to
clear
the error – otherwise no payout will occur.
To Refill Hopper
:
1)
Insert front
key above Payout tray and turn it & put back
in original
position.
2)
‘REFILL’ and
‘HOPPER’
will be displayed on screen, press middle HOLD button to enter the
refill
screen and the Hopper level will be displayed.
3)
Ensure
the hopper contains the amount
onscreen, if hopper needs topped up enter £1 coins through the coin
acceptor –
the software will allow the hopper to be topped up higher than the 200
level if
wanted.
HOPPER
DUMPING :
When
Hopper is dumped it
does not affect current Hopper level for game :
1)
Start
Hopper Dump by turning bottom cashbox key above meters and
turning off
again
2)
Press
HIGH to start dump
3)
The
coins will be counted on-screen
4)
Hopper
will stop automatically or hit LOW
5)
Make
note of count figure
6)
Place
Coins Back into Hopper
7)
Check
current refill level using Front Key-switch and exit
8)
Ensure
Refill levels Match – add or remove coins physically from hopper to
match